work principle of vacuum dust collector There are dust bag cleaning and artificial beating cleaning. Dust bag self-cleaning only depends on the dust layer attached to the surface of the dust bag falls off, so the dust fall is not large, and the pressure loss is only reduced. The pressure loss of the filter bag is generally reduced to 300pa. However, the dust removal rate decreased in a short time after re-operation. With the increase of filtration time, the dust collection amount on the surface of the dust bag increases, and the pressure loss limit also increases. In actual operation, the air volume in the system is reduced due to the increase of the pressure loss of the dust bag, and the pressure loss is reduced to. Therefore, the limit of this pressure loss is the fan pressure head when the air volume tends to 0. Under different dust-bearing gas concentrations and loads, with the increase of filtration time, the pressure loss of large concentration increases quickly, and the pressure loss of large load also increases quickly.

Below, explain the installation process of the work principle of vacuum dust collector in detail:

First, when installing the work principle of vacuum dust collector, it is necessary to pay attention to the damage of the box and accessories, and the aperture of the tank top is less than the dust collector.

Two, the work principle of vacuum dust collector need to be checked before installation, all the parts are in good condition, if there is damage or deformation found, to repair in time, after correct installation.

Three, the installation of the filter cylinder in the dust collector needs to be fixed vertically in it, and it should be installed compact.

Four, the tank top should be welded on the ash storage tank top. Then switch on the induced draft fan.

Five, the dust collector needs the seal inside the box, can not appear any air leakage phenomenon.

Six, and then connect the air compressor, and also need soft connection. This is the way to connect to the dust collector reservoir.

work principle of vacuum dust collector selection Wear good protective gloves before operation and maintenance, cut off the power supply before operating the equipment, check whether the stability of all removable parts is good before use, and all filter elements should be securely fixed on the flower hole plate. Also check to see if the detection window is closed. After use, the equipment should be tested every six months, and maintenance should be carried out. Our bag dust collector needs to determine the sealing inside the box body, and can not appear any air leakage phenomenon.

The work principle of vacuum dust collector in the installation of the filter cylinder should be fixed vertically in it, and the installation should be compact. It is important to check the bag dust collector regularly, because we can find the problems existing in the work principle of vacuum dust collector in time, which can be solved in time. The top of the tank should be welded to the top of the ash storage tank. Then the induced draft fan is connected and then the air compressor is connected, and soft connection is needed. This is the way to connect to the dust collector reservoir. All the parts are in good condition. If they are found damaged or deformed, they should be repaired in time and installed after no error.

work principle of vacuum dust collector https://www.kaisenfilter.com/What-is-the-principle-of-vacuum-dust-collector-and-what-are-the-components.html